baltz 3 外国人で日本語間違えたら申し訳ございません。もともとパーツとしてこれを買ったんですがせっかくなんで届いたものをそのままを使いました。まずガードをつけると、フェンスが左側しか使えない。ですがフェンスもしめようとしてもちょっとずらしてしまう事があります。べつのクランプと木材を使ってそっちのほうが出来ました。次はゲージが45度にせっとしてたけど結局45度じゃありませんでした。ちょっとずれています。丸ノコとガードのアジャスト時間がかかる。まっすく切りたいならいろんな確認をしないといけません。僕は外で作業をしていますので毎回取り外して、つけないといけないので毎回アジャストをしないといけません。そういっても、結構しっかりしているのでいいと思います。丸ノコだけではなく、ルーター、ジグソーもつけるのでこれを買いました。このままで使わないつもりだったので、パーツとしていいと思います.I got this to use a parts but since I got it, I thought I'd use it as is. It's quite stable as is, however, the fence that came with it can't be used on the right side of the blade if the splitter is connected. The miter gauge is quite loose in the slot and because the slot is shallow, it could slip out of the slot easily. Also, the gauge will say 45 degrees but when set to it and checked onto a speed square, it is off by a few degrees. If you don't pay attention to the gauge guides and measure it to a true 45 degrees, you can get good cuts. Same with the miter gauge, if you hold it firmly against one without slipping during the cut, you can get a good cut. I work outdoors so I need to remove and install the saw each time so making the adjustments to make sure it's straight with the splitter and until I'm satisfied with it, adjusting will take some time, but once you get it right, it makes some good cuts.I used this for parts for my own table saw because it can attach a trim router, jigsaw, and a circular saw. So for me with that purpose, I thought this table was quite good.
売買 キャプテンスタッグ CAPTAIN STAG キャンプマット レジャーシート EVA フォーム マット qdtek.vn